The GenapSys Sequencing Prep System

The GenapSys Sequencing Prep System replaces the manual clonal amplification step in the GenapSys Sequencer workflow with a load-and-go process that automates template preparation and enrichment in one device. This small-footprint instrument uses cartridge-based reagents, and employs magnetic bead technology to isolate template-positive particles that can be subsequently loaded onto GenapSys sequencing chips.

Simplified workflow saves time and labor

  • Intuitive instrument set-up via touch screen interface
  • Increased lab productivity—just 20 minutes of set-up time followed up uttended 4-hour run

Walk away Automation

  • Perform multiple runs in a single day
  • Fully automated workflow requires minimal user intervention

Reduced run variability

  • Reduced user intervention minimizes sources of user introduced variability


Dimensions (W x D x H) 28.5 cm x 41.1 cm x 32.8 cm (11.2 in. x 16.2 in. x 12.9 in.)
Weight (W x D x H) 14.6 kg (32.1 lbs.)
Operating environment Temperature: 19°C to 25°C (22°C ±3°C)
Humidity: Noncondensing 30-75% relative humidity
Altitude: Less than 2000m (6500 ft)
Air Quality: Pollution degree rating of II
Heat Output: 852 BTU/hr @ 250W
For Indoor Use Only
Power requirements 100 – 240 VAC, 50-60 Hz, 250W
Instrument configuration RFID tracking for consumables
Radio frequency identifier (RFID) Frequency 13.56 MHz
Power: Supply current 120 mA
Product safety and compliance NRTL certified IEC
FCC/IC Approved

Get in touch with GenapSys.

Receive the latest news or request a quote.